Jefferson Lab's Workbench Projects

Assembly

1. Install the four LEDs and the four toggle switches in their respective holes.

LEDs and toggle switches have been installed.

1. Flipping the base over so that you can access its interior, wire the LEDs and switches together to make the kind of circuit you desire. Sample circuits can be found in Appendix B (Point to Point Wiring Guides) and Appendix C (Circuit Diagrams).
2. Once the wiring is complete, secure the 9 Volt battery clip and the LEDs to the base with epoxy.

All wiring is complete and the LEDs and battery clip are secured to the base with epoxy.

1. Attach a 9 Volt battery to the connector and place it in the battery clip. If all has gone well, your device should now be working!

Next Page