Jefferson Lab's Workbench Projects

Component List

• 1 × 2 plank of white pine (roughly 30 inches needed)
• 1/4" thick plywood (roughly 1/2 square foot needed)
• 1 1/2" 4d finishing nails (about 8 needed)
• 22 gauge hook-up wire (roughly 1 foot needed)
• green LEDs (T-1 3/4 package, 4 needed)
• toggle switches (SPDT or SPST, 4 needed)
• 1/4 Watt resistor(s) (exact numbers and values depend on the type of circuit being built)
• 9 Volt battery (1 needed)
• 9 Volt battery connector (1 needed)
• 9 Volt battery holder (1 needed)
• adhesive feet (4 needed)
• 5 minute epoxy (1 packet needed)
• wood glue

All of the components have been gathered. All of the wood has been cut and holes for the hardware have been drilled.

Next Page